guide nozzle造句
例句與造句
- Due to physical reasons, it is unavoidable that the wire leaves the wire guiding nozzle at an angle of approx . 90?
- An advantage of the needle winding technology is the fact that the needle support carrying the wire guiding nozzle is normally coupled to a CNC coordinate system.
- It means for the wire guiding movement that the smaller the distance of the wire guiding nozzle towards the coil, the more precise the tracking must be.
- A targeted placing of the wire is nevertheless only possible to a limited extend since the wire is pulled at an angle of 90?from the wire guiding nozzle resulting in an undefined bulging.
- Since the wire guiding nozzle can be moved freely throughout the room, it is possible for the nozzle to terminate the wire at the contact points if equipped with an additional swivel device.
- It's difficult to find guide nozzle in a sentence. 用guide nozzle造句挺難的
- Enameled copper wires up to a diameter of approx . 0.3 mm can be torn normally by a tearing pen that passes close to the post of the coil or the wire guiding nozzle itself.
- In order to be able to control the positions of the wire guiding nozzle in relation to the component to be wound, even with different component geometries, normally three CNC axes are used for the method with a wire guiding nozzle.
- In order to be able to control the positions of the wire guiding nozzle in relation to the component to be wound, even with different component geometries, normally three CNC axes are used for the method with a wire guiding nozzle.
- Especially wire bends that develop due to wire deflections caused by, e . g ., pulleys, wire eyelets or even the wire guiding nozzle itself within the wire feeder of a winding machine can lead to deformations that remain on the winding of a coil.
- This enables the terminating to coil body posts ( the posts are also intended to make contacts by soldering or welding ) : By letting the three axes run in a way that a spiral movement of the wire guiding nozzle around the initial winding post is resulting, it is possible to fix the start or end wire of a coil by the so-called termination.